Fluido de Limpieza para Unidades de Control de Temperatura de Aceite Caliente
El nuevo Paratherm SC® está específicamente formulado para disolver y evitar depósitos de lodos y trozos de carbón que se producen frecuentemente en unidades de control de temperatura de aceite caliente donde se han utilizado fluidos de transferencia térmica de base de petroleo o glicol. El fluido SC® es un líquido sinergético de varios componentes que es compatible con todos los fluidos térmicos de base de aceite mineral y con muchos de los fluidos sintéticos. Usado caliente (máx. 150°F) o frío proporciona unas propiedades excelentes para la eliminación de lodos.
El líquido Paratherm SC® puede ser reutilizado después de que materia sólida haya caído al fondo del recipiente o se haya filtrado. Cuando finalmente el fluido se haya gastado puede combinarse con otros líquidos de lavado y eliminarse convencionalmente.
Reciba un e-mail instantáneo sobre Paratherm SC® con la información del producto, los datos de seguridad y datos sobre sus propiedades físicas y térmicas. Simplemente introduzca su dirección de correo electrónico aquí:
¿Limpio sin desmontaje? Èchele un vistazo a Paratherm LC™
+Lea las instrucciones de uso de Paratherm SC®
–Lea Menos
Instructions for Use
NOTE: Cleaning and maintaining your hot oil temperature control system will be a lot easier if you replace the drain plug with a valve mounted externally.
Drain existing fluid while warm if possible.
Replace drain plug with ball or globe valve.
Bottom-fill system with fluid so that reservoir tank has approximately 1″ to 2″ of fluid in bottom, or enough to start pump.
Circulate cold for 3 to 4 hours. If reservoir needs to be cleaned, run discharge hose into tank through vent or open vent to agitate fluid in tank.
Let system soak overnight.
Start system up and circulate from 1 to 4 hours. Fluid works faster when warm. Heat to max of 150°F if possible.
NOTE: Do not circulate through expansion tank while system is hot.
If required, turn off heat and allow fluid to cool with pump running.
When fluid temperature reaches ambient (80°F), begin to drain fluid while pump is still operating. Shut off pump when pressure begins to fluctuate. Continue draining system.
Refill system with Paratherm fluid or any compatible mineral oil-based product. Set temperatures at 150°F and circulate for 1-2 hours. Shut down and drain immediately. Repeat if odor still present.
Refill system with Paratherm heat transfer fluid and put unit back into service.
Packaging
The SC liquid is available in 5-gallon pails and 55-gallon drums. Shipment is via UPS and motor freight, and is shipped same-day if we have your purchase order by 10:00 AM.
Technical Assistance
Our technical expertise is available to you in the conceptual stage, during planning and design, and through system construction, start-up and operation. We want to work closely with you in the recommendation of proven thermal fluidsystems, components, supplies and procedures.
We also advise on system cleaning and repair,should these become necessary. And if yourapplication calls for fluids that we are unable toprovide, Paratherm will assist you with the names and phone numbers of competitors’ engineers that can help.
Additional Information
Paratherm has available technical data sheets covering a variety of thermal fluid and systemtopics including fire prevention, system performancetracking, recommended components,draining, flushing and charging and fluid analysis, among others. We’d be pleased to forward these to you upon request.